Home >>  Electronics  >>  Fingerprint based ignition

The goal of our project is to eliminate the need to car you car keys and therefore eliminating the possibility of them getting misplaced. Basically our design allows the user of a vehicle to enter and start his/her vehicle simply at the touch of a finger. We planned to incorporate a fingerprint sensing device and processor into the driver side door of a vehicle. An authorized user then simply puts his/her finger in the sensor to initiate a timing cycle. Upon authorization the user will have a certain amount of time to enter and start the vehicle. In our prototype we simulate this by having our system enable and disable the remote control of a toy car. An authorized user places his/her finger on the sensor and starts a timing cycle. Our timer will then time from a minimum of 18 seconds to a maximum of 3 minutes and 10 seconds to enable the remote. With an enabled remote the user can perform all the functions on the remote, upon time expiration the remote is disabled and the functions can no longer be performed. All the devices are powered by converters we built. These converters run off a 12 volt car battery and step that voltage down to 5 volts. All the circuits are in the prototyping stages and would need improvement in a final design.

  

plz cn u provide me the module for fingerprint recognisation..i need it..urgent.

cn u mail me on my email id- shuchienator@gmail.com

Quote by --project

Quote by --project

can u please sent me the details of this project on my Quote by --project

Quote by --project

  

pls can u give me the further details to my id(reshyan1212@yahoo.com)

  

please email me the details of this project, i kinda need it, please

here: mienmar_juuichi@yahoo.com

  

i would like to do this project........it sounds really nice.....

please send me the details.....

b.dhiru@gmail.com 

  

can u please send us the project details to the followin mail address 1.aditya3657@gmail.com 2.shashidhargis@rediffmail.com